SKYCITY LANDING BEACON

Straight from May's Patreon comes this SkyCity Landing Beacon. This is a good addition to the SkyCity Platforms set. You'll need a bit of 1.7mm FDM filament to finish to act as the aerial bit, straighten and cut to the desired length and pop in the top, bingo!
This is mainly for FDM printers, but could be printed on an SLA printer, but you'll have to find a bit of wire or something for the aerial bit. I have some great settings with which to print this set on an FDM printer that give excellent detail and quality, but at a greatly reduced time (24% faster than usual at that layer height):

Layer Height: 0.12 mm

Initial Layer Height: 0.12 mm

Build Plate Adhesion: RAFT

Use Adaptive Layers: True

Wall Thickness: 0.8 mm

Infill Density:  5 %

Infill Pattern: Lines

Printing Temperature: 210.0 C  

(I use Sun PLA+ and this is a good temperature for that, you might want to adjust it according to your PLA manufacturers recommended temperature)

Inner Wall Speed: 50 mm/s

Turn on Ironing too if you want a smooth finish on those flat areas, it adds a little bit of time though.

PLEASE NOTE: THIS IS NOT A PHYSICAL PRODUCT; YOU WILL RECEIVE DIGITAL FILES DESIGNED FOR 3D PRINTING AT HOME

By purchasing this product, you agree to abide by the following terms and conditions:

These files are for personal use only. You may not sell, share, or distribute the files, prints, or their derivatives under any circumstance.

You may modify or resize the models or files for personal use only. You may not sell or distribute modified models or any models and files containing portions of Squamous Miniatures models.