DOWNED QUADMECH COCKPIT

Straight from March's Patreon comes this Downed Quadmech Cockpit. It's in a snowy sculpt, but you could easily make that mud or sand depending on the colour you paint it I guess! It's got a couple of unfortunate pilots in the wreckage, all dead and stuff.
This is mainly for FDM printers, and the main large part will print without supports. The second piece, a gun, will have to be supported, I find the gun vertical works best, and don't use the settings below, use more infill. This will just fit on a large SLA printer, such as the Elegoo Saturn. It would have to be hollowed and a load of drain holes put in the bottom. Chitubox is great for this sort of thing.
I have some great settings with which to print this set on an FDM printer that give excellent detail and quality, but at a greatly reduced time (24% faster than usual at that layer height):

Layer Height: 0.12 mm

Initial Layer Height: 0.12 mm

Build Plate Adhesion: RAFT

Use Adaptive Layers: True

Wall Thickness: 0.8 mm

Infill Density:  5 %

Infill Pattern: Lines

Printing Temperature: 210.0 C  

(I use Sun PLA+ and this is a good temperature for that, you might want to adjust it according to your PLA manufacturers recommended temperature)

Inner Wall Speed: 50 mm/s

It's made for FDM printers, but you could probably have a go at printing it on an SLA printer, but you'll have to hollow the parts,  put in some drain holes, and scale them to fit on smaller printers such as the Anycubic Photon.

PLEASE NOTE: THIS IS NOT A PHYSICAL PRODUCT; YOU WILL RECEIVE DIGITAL FILES DESIGNED FOR 3D PRINTING AT HOME

By purchasing this product, you agree to abide by the following terms and conditions:

These files are for personal use only. You may not sell, share, or distribute the files, prints, or their derivatives under any circumstance.

You may modify or resize the models or files for personal use only. You may not sell or distribute modified models or any models and files containing portions of Squamous Miniatures models.