DEAD ICEMAW IN SNOWDRIFT

Straight from March's Patreon comes this Dead Icemaw in Snowdrift.
This is mainly for FDM printers, but I've included a pre-supported version for an SLA printer as small as the Anycubic Photon. I have some great settings with which to print this set on an FDM printer that give excellent detail and quality, but at a greatly reduced time (24% faster than usual at that layer height):

Layer Height: 0.12 mm

Initial Layer Height: 0.12 mm

Build Plate Adhesion: RAFT

Use Adaptive Layers: True

Wall Thickness: 0.8 mm

Infill Density:  5 %

Infill Pattern: Lines

Printing Temperature: 210.0 C  

(I use Sun PLA+ and this is a good temperature for that, you might want to adjust it according to your PLA manufacturers recommended temperature)

Inner Wall Speed: 50 mm/s

It's made for FDM printers, but you could probably have a go at printing it on an SLA printer, but you'll have to hollow the parts,  put in some drain holes, and scale them to fit on smaller printers such as the Anycubic Photon.

PLEASE NOTE: THIS IS NOT A PHYSICAL PRODUCT; YOU WILL RECEIVE DIGITAL FILES DESIGNED FOR 3D PRINTING AT HOME

By purchasing this product, you agree to abide by the following terms and conditions:

These files are for personal use only. You may not sell, share, or distribute the files, prints, or their derivatives under any circumstance.

You may modify or resize the models or files for personal use only. You may not sell or distribute modified models or any models and files containing portions of Squamous Miniatures models.